Published by:
CGP EDU Academic Team
Published on: August 22, 2026
PART -A (PHYSICS)
In the density measurement of a cube, the mass and edge length are measured as 
and 
, respectively. The error in the measurement of density is:
A
B
C
D
Text Solution
Verified by ExpertsThe correct answer is:
-
Maximum % error in 
will be given by
This is not applicable as error is big.
& 
──────────────────────────────────────────────────────────────────────────────────────────
Prepare Smarter with CGP Edu
Get practice questions, solutions, and test series in one place.
Write a Review
Share your experience with this question and solution.
Commentary
Send your comment, doubt, correction, or feedback to admin.
Similar Questions
Explore conceptually related problems
The total number of turns and cross-section area in solenoid is fixed. However, its length is vari…
The figure shows a Young's double slit experimental setup. It is observed that when a thin transpar…
A system of three charges are placed as shown in the figure:
If > , the potential energy of the …
A moving coil galvanometer has resistance and it indicates full deflection at current. A voltmete…
If ' ' is the mass of water that rises in a capillary tube of radius ' ', then mass of water whic…
An NPN transistor is used in common emitter configuration as an amplifier with load resistance. Si…