The surface tension of soap solution is 3. 5 x 10 -2 N m -1 . The amount of work done required to increase the radius of soap bubble from 10 cm to 20 cm is _____x10 -4 J. (take 
)
Text Solution
Verified by ExpertsThe correct answer is:
CHECK THE SOLUTION.
(264)
The amount of work done is equal to the change in the surface energy to increase the radius of the bubble. The formula to calculate the change in surface energy is given by
U = 2(T x 
A) ...
Substitute the values of the known parameters into equation to calculate the required work done.
=2 x 1.32 x 10 -2 =264 x 10
-4 J
Prepare Smarter with CGP Edu
Get practice questions, solutions, and test series in one place.
Write a Review
Share your experience with this question and solution.
Commentary
Send your comment, doubt, correction, or feedback to admin.
Similar Questions
Explore conceptually related problems
A Spherical ball of radius 1mm and density 10.5 g/cc is dropped in glycerine of coefficient of visc…
A spherical drop of liquid splits into 1000 identical spherical drops. If u i is the surface energy…
A metal block of base area 0.20 m 2 is placed on a table, as shown in figure. A liquid film of thic…
The surface of water in a water tank of cross section area 750 cm 2 on the top of a house is h m. a…
An air bubble of diameter 6 mm rises steadily through a solution of density 1750 kg m -3 at the rat…
Figure below shows a liquid being pushed out of the tube by a piston having area of cross section 2…