When the screw and stud touch each other, the edge of certain screw gauge is to the right of the 0 mark on the main scale and 5th division of the circular scale coincides with the line of graduation, then what is the value of zero error?
Text Solution
Verified by ExpertsThe correct answer is:
C
Here, the zero error is positive.
Prepare Smarter with CGP Edu
Get practice questions, solutions, and test series in one place.
Write a Review
Share your experience with this question and solution.
Commentary
Send your comment, doubt, correction, or feedback to admin.
Similar Questions
Explore conceptually related problems
What is the least count of the vernier caliper?
What is the least count of commonly available vernier?
When the zero mark on the vernier scale lies towards the right side of the zero mark of the main sc…
When the zero mark on the vernier scale lies towards the left side of the zero mark of the main sca…
If observed reading is OR, corrected reading is CR, zero error is ZE and zero correction is ZC , th…
When the jaws of a standard vernier are together, the 6th main scale division coincides with the 7t…