The transfer characteristics of a base biased transistor has the operation regions, namely, cutoff, active region and saturation region. For using the transistor as an amplifier it has to operate in the
Text Solution
Verified by ExpertsThe correct answer is:
A
when the transistor is used in the cutoff of saturation region it acts as a switch. On the other hand for using the transistor as an amplifier, it has to operate in the active region.
Prepare Smarter with CGP Edu
Get practice questions, solutions, and test series in one place.
Write a Review
Share your experience with this question and solution.
Commentary
Send your comment, doubt, correction, or feedback to admin.
Similar Questions
Explore conceptually related problems
A silicon speciman is made into a P-type semi-conductor by dopping, on an average, one Indium atom …
The typical ionisation energy of a donor in silicon is
A 2V battery is connected across the points A and B as shown in the figure given below. Assuming th…
The diode used in the circuit shown in the figure has a constant voltage drop of 0.5 V at all curre…
For a transistor amplifier in common emitter configuration for load impedance of 1 k Ω Ω (h fe = 50…
In semiconductor the concentrations of electrons and holes are 8 × × 10 18 /m 3 and 5 × × 10 18 /m …