Published by:
CGP EDU Academic Team
Published on: September 12, 2026
A resistance of 
is connected to a source of an alternating potential 
. The time taken by the current to change from its peak value to rms value, is
A
B
C
D
Text Solution
Verified by ExpertsThe correct answer is:
A
The current and potential difference are in phase with the resistance. So, the time taken would be same as time for voltage to change from 
that is peak value to rms value.
Time taken by voltage to achieve its rms value of 
.
Prepare Smarter with CGP Edu
Get practice questions, solutions, and test series in one place.
Write a Review
Share your experience with this question and solution.
Commentary
Send your comment, doubt, correction, or feedback to admin.
Similar Questions
Explore conceptually related problems
Consider four conducting materials copper, tungsten, mercury and aluminium with resistivity and r…
Model a torch battery of length l to be made up of a thin cylindrical bar of radius 'a' and a conce…
Two resistors and are connected in series across a 6 V battery. The potential difference measured…
In the circuit, given in the figure currents in different branches and value of one resistor are sh…
A circuit to verify Ohm's law uses ammeter and voltmeter in series or parallel connected correctly …
In the figure shown, the current in the battery is close to